Acer Altos G530 Series User Manual page 57

4 Install the hot-plug cage.
(1) Slide the cage into the chassis. The cage is locked to the chassis
with an audible click.
5 Connect the following cables to their corresponding connectors on
the SATA RAID backplane board, mainboard and adapter:
Important: If a four-bay hot-plug SATA HDD cage is already
installed in the top HDD bay, you must block the J1 jumper. Set
pins 2 and 3 to short.
(1) Attach the SATA data cable to the SATA HDD connector on the
backplane board (1), then connect the other end of the cable
to the SATA connector on the SATA RAID card.
Note: SATA connectors on the controller are keyed. Make sure
the SATA data cables are properly connected to its corresponding
connectors on the SATA RAID card.
47