Lenovo ThinkStation P320 Hardware Maintenance Manual page 145

Figure 129. Installing a screw to secure the Wi-Fi card module
3. Connect the front and rear antenna cables to the Wi-Fi card module.
Figure 130. Installing the Wi-Fi antenna cables
Wi-Fi adapter card
To install the Wi-Fi adapter card, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Preparing your computer and removing the computer cover" on page
69.
3. Install the Wi-Fi adapter card into the PCIe x1 card slot on the system board. See "Parts on the system
board" on page 11.
4. If the installed Wi-Fi card module supports the Bluetooth function, connect a Bluetooth cable from the
Bluetooth connector on the Wi-Fi adapter card to the USB 2.0 connector on the system board.
5. Pivot the card latch to the closed position to secure the Wi-Fi adapter card.
.
Chapter 8 Hardware removal and installation
137