Figure 112. Removing the thermal sensor
5. Insert the cable of the new thermal sensor into the left hole
the plastic holder with the two holes
position.
Figure 113. Installing the thermal sensor
6. Reconnect the thermal sensor cable to the thermal sensor connector on the system board. See "Parts
on the system board" on page 11.
7. Reinstall the front bezel. See "Front bezel" on page 70.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 139.
128
P320 Hardware Maintenance Manual
1
1
2
and
in the chassis. Press the plastic holder until it snaps into
in the chassis. Then align the two tabs on