Table of Contents
Advertisement
Chapter 12
Avaya P330 Layer 3 Features
Static Routing Configuration CLI Commands
In order to...
Establish a static route
Remove a static route
Set the maximum number of route
entries in the routing table
Set the maximum number of route
entries in the routing table to the
default value
Define a default gateway (router)
Remove the default gateway
(router)
Delete all the dynamic routing
entries from the Routing Table
Display information about the IP
unicast routing table
Display a routing table for a
destination address
Display the static routes
Display the number of routes
known to the switch
Route Preferences
The routing table may contain routes from different sources. Routes to a certain
destination may be learned independently from RIP and from OSPF, and at the
same time, a static route can also be configured to the same destination. While
metrics are used to choose between routes of the same protocol, protocol
preferences are used to choose between routes of different protocols.
The preferences only apply to routes for the same destination IP address and mask.
They do not override the longest-match choice. For example, a high-preference
static default route will not be preferred over a RIP route to the subnet of the
destination.
P330 protocol preferences are listed below from the most to the least preferred:
1
Local (directly attached net)
98
Use the following command...
ip route
no ip route
ip max-route-entries
no ip max-route-entries
ip default-gateway
no ip default-gateway
clear ip route
show ip route
show ip route best-match
show ip route static
show ip route summary
Avaya P332GT-ML User's Guide
Advertisement
Table of Contents
Troubleshooting
