Table of Contents
Advertisement
BUILT-IN
ASKO dryers can be installed beneath a cabinet
or worktop with a minimum height of 34" (864mm).
There must be a gap of about 1/2" (12mm) all around
the machine, including between the rear edge of the
machine and the back wall. The opening width must
be at least 24-1/2" (622 mm).
The height adjustment for the dryer is 33-1/2" to
34-1/2" (850 mm to 876 mm). Do not raise it higher
than 34-1/2" (876 mm). Hole measurements are from
center of hole.
Customer Care Center, 1-800-898-1879, www.askousa.com
Install in a closet
ASKO's front panel controls make it possible to
install the washers and dryers in a closet. Make
sure there is a ½" (12mm) minimum clearance
between units and cabinet or wall. To ensure
proper ventilation, we recommend louvered doors.
Otherwise there must be ventilation openings in
the door. See illustration for minimum ventilation
openings:
Ensure the dryer door can be opened without
hindrance after installation.
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause a fault.
7
Advertisement
Table of Contents
