Table of Contents
Advertisement
Installation instructions
Built-in
ASKO dryers can be installed beneath a
cabinet or worktop with a minimum height of
34" (864mm). There must be a gap of about
1/2" (12mm) all around the machine, including
between the rear edge of the machine and the
back wall. The opening width must be at least
24-1/2" (622 mm).
NOTE!
The height adjustment for the dryer is 33-
1/2" to 34-1/2" (850 mm to 876 mm). Do not
raise it higher than 34-1/2" (876 mm). Hole
measurements are from center of hole.
4
Install in a closet
ASKO's front panel controls make it possible to
install the washers and dryers in a closet. Make
sure there is a ½" (12mm) minimum clearance
between units and cabinet or wall. To ensure
proper ventilation, we recommend louvered
doors. Otherwise there must be ventilation
openings in the door. See illustration for
minimum ventilation openings:
NOTE!
Ensure the dryer door can be opened without
hindrance after installation.
NOTE!
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause a fault.
Customer Care Center
1-800-898-1879
www.askona.com
Advertisement
Table of Contents
