Table of Contents
Advertisement
How to stack a dryer onto the washing machine (ASKO):
There is a cardboard box in the dryer drum, containing the vacuum feet and the tipping guard.
A
B
1
4
1
2
3
1
2
3
2
Customer Care Center, 1-800-898-1879, www.askousa.com
The tipping guard consists of two metal parts (A +
1
B).
Use two screws to attach the A part to the back of the
dryer.
Undo the screw on the back side of the washing
2
machine.
Use the screw to attach the tipping guard (B part)
3
to the back of the washing machine.
Level the washing machine so that it is stable.
4
1. Level the washing machine in longitudinal and
traverse direction by rotating the adjustable feet
using a No. 32 spanner.
The feet allow levelling by +/- 1 cm.
2. After adjusting the height of the feet, fi rmly
tighten the jam nuts (counter nuts) using a
spanner No 17, by turning them towards the
bottom of the washing machine
3. Tighten the jam nuts (counter nuts).
Set the dryer feet:
5
1. Tighten the front two feet all the way in.
2. Undo the back feet by 3.5 turns or 5 mm; then,
fasten the jam nuts towards the bottom of the
appliance
.
Place the dryer onto the washing machine:
6
1. Lift the front part of the dryer by 5 to 10 cm.
2. Attach the vacuum feet onto the front feet of the
dryer.
3. Push the dryer into the tipping guard (so that
the B part is inserted into the A part) and
release it (See fi gure on previous page).
Make sure the tipping guard is "locked"!
.
Advertisement
Table of Contents
