Cycles: Coordinate Transformations | WORKING PLANE (Cycle 19, DIN/ISO: G80, software option 1)
Cycle parameters
Rotary axis and angle?: Enter the axis of
rotation together with the associated tilt angle.
The rotary axes A, B and C are programmed
using soft keys. Input range -360.000 to 360.000
If the TNC automatically positions the rotary axes, you can enter
the following parameters:
Feed rate? F=: Traversing speed of the rotary
axis during automatic positioning. Input range 0
to 99999.999
Set-up clearance? (incremental): The TNC
positions the tilting head so that the position
that results from the extension of the tool by the
set-up clearance does not change relative to the
workpiece. Input range 0 to 99999.9999
Resetting
To reset the tilt angles, redefine the WORKING PLANE cycle and
enter an angular value of 0° for all axes of rotation. You must then
program the WORKING PLANE cycle once again and respond to
the dialog question with the NO ENT key to disable the function.
HEIDENHAIN | User's manual for cycle programming | 10/2017
10
307