Please Note While Programming; Cycle Parameters - HEIDENHAIN TNC 640 User Manual

Cycles: Coordinate Transformations | ROTATION (Cycle 10, DIN/ISO: G73)

Please note while programming:

An active radius compensation is canceled by defining
Cycle 10 and must therefore be reprogrammed, if
necessary.
After defining Cycle 10, you must move both axes of the
working plane to activate rotation for all axes.

Cycle parameters

Rotation: Enter the rotation angle in degrees (°).
Input range –360.000° to +360.000° (absolute or
incremental)
HEIDENHAIN | User's manual for cycle programming | 10/2017
NC blocks
12 CALL LBL 1
13 CYCL DEF 7.0 DATUM SHIFT
14 CYCL DEF 7.1 X+60
15 CYCL DEF 7.2 Y+40
16 CYCL DEF 10.0 ROTATION
17 CYCL DEF 10.1 ROT+35
18 CALL LBL 1
10
301