Contour (Cycle 14, Din/Iso: G37); Please Note While Programming; Cycle Parameters - HEIDENHAIN TNC 640 User Manual

Fixed Cycles: Contour Pocket | CONTOUR (Cycle 14, DIN/ISO: G37)
7.2

CONTOUR (Cycle 14, DIN/ISO: G37)

Please note while programming:

All subprograms that are superimposed to define the contour are
listed in Cycle 14 CONTOUR.
Cycle 14 is DEF active which means that it becomes
effective as soon as it is defined in the part program.
You can list up to 12 subprograms (subcontours) in Cycle
14.

Cycle parameters

Label numbers for the contour: Enter all label
numbers for the individual subprograms that
are to be superimposed to define the contour.
Confirm every label number with the ENT key.
When you have entered all numbers, conclude
entry with the END key. Entry of up to 12
subprogram numbers 1 to 65535.
HEIDENHAIN | User's manual for cycle programming | 10/2017
7
219