The Character Set Of The Fixed Cycle 225 Engraving Was - HEIDENHAIN TNC 640 User Manual

New cycle functions of software 34059x-04

The character set of the fixed cycle 225 Engraving was

expanded by more characters and the diameter sign See
"ENGRAVING (Cycle 225, DIN/ISO: G225)", page 340
New machining cycle 275 Trochoidal milling See "TROCHOIDAL
SLOT (Cycle 275, DIN/ISO: G275)", page 247
New machining cycle 233 Face milling See "FACE MILLING
(Cycle 233, DIN/ISO: G233)", page 194
In Cycle 205 Universal Pecking you can now use parameter
Q208 to define a feed rate for retraction See "Cycle parameters",
page 100
In the thread milling cycles 26x an approaching feed rate was
introduced See "Cycle parameters", page 138
The parameter Q305 NUMBER IN TABLE was added to Cycle
404 See "Cycle parameters", page 520
In the drilling cycles 200, 203 and 205 the parameter Q395
DEPTH REFERENCE was introduced in order to evaluate the T
ANGLE See "Cycle parameters", page 100
Cycle 241 SINGLE-LIP DEEP HOLE DRILLING was expanded
by several input parameters See "SINGLE-LIP DEEP-HOLE
DRILLING (Cycle 241, DIN/ISO: G241)", page 109
The probing cycle 4 MEASURING IN 3-D was introduced See
"MEASURING IN 3-D (Cycle 4)", page 633
12
Fundamentals | New cycle functions of software 34059x-04
HEIDENHAIN | User's manual for cycle programming | 10/2017