Table of Contents
Advertisement
Installation
This section describes the installation and setup of the SW HDMI Series switchers. Topics
include:
•
•
•
•
•
•
Installation Overview
To install and set up the SW HDMI switcher:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Installation Overview
Rear Panel Features
Wiring the Power Connector (Optional)
Wiring for RS-232 Control
Connecting to the USB Port
Enabling Auto-input Switching
Turn off all equipment and disconnect it from the power source.
(Optional) Mount the switcher on a rack shelf or furniture (see
SW
HDMI" on page 31).
Connect HDMI input sources to one or more of the SW HDMI input connectors.
Connect an HDMI output device to the output connector.
Connect control devices. Connect your computer to one of these SW HDMI ports
to configure and control the switcher via SIS commands or the Universal Switcher
Control Program:
RS-232 port — Pins 1, 2, and 3 of the Remote port (
•
diagram
on the next page) for Serial RS-232 control. (See
Control" on page 7 for connection procedures.)
Config port — USB mini-B connector (
•
"Operation" section) for USB control. (See
page 8 for connection procedures.)
(Optional) Enable auto-input switching. Use a jumper to connect pins 4 and 5 of
the 5-pole captive screw plug that you plugged into the Remote connector in step 4
(see
"Enabling Auto-input
Power on the output display.
Connect power to the switcher (see
"Operation" section).
Power on the source devices.
f
on the
front panel diagram
"Connecting to the USB
Switching" on page 10).
"Powering On the
SW HDMI Series • Introduction
"Mounting the
d
on the
rear panel
"Wiring for RS-232
in the
Port" on
Switcher" in the
4 4
Advertisement
Table of Contents
