Table of Contents
Advertisement
On the Add Device window, the path to the new firmware file is displayed in the
field.
Figure 19.
Path to the New Firmware File on the Add Device Window
10.
If this is the only device to which you are uploading firmware, click
switcher information is added to the Devices section of the Firmware Loader window
and the Add Device window closes.
If you will be uploading the firmware to multiple SW HDMI switchers that are
connected to your computer, do the following:
a.
Click
. Your first device is added to the Devices section of Firmware
Add Next
Loader window, and the Add Device window remains open.
b.
For each additional device you want to add to the Firmware Loader window,
repeat steps 5 through 9, then click
c.
For the last device, click
the Add Device window.
Figure 20.
Firmware Loader Screen with an SW HDMI Added
Add Next
.
(instead of
Add
Add Next
SW HDMI Series • Remote Communication and Control
Path
Add
. The
) to add the device and to close
26
Advertisement
Table of Contents
