Table of Contents
Advertisement
5.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
6.
Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw head protrudes.
7.
Align the centers of the slots in the brackets with the mounting screws and place the
unit against the surface, with the screw heads through the bracket slots.
8.
Slide the unit slightly forward or back, then tighten all four screws to secure it in
place.
SW HDMI Series • Reference Information
34
Advertisement
Table of Contents
