EVGA X299 DARK Owner's Manual page 97

EVGA X299 DARK (151-SX-E299)
Once into the H/W Monitor section, you can see the temperature monitors across the
top. Below the monitors are the two (2) PWM fans: CPU1_FAN, CPU2_FAN, and
CHA_FAN. The PWM fans are set to "Smart," which means the PWM controller is
using a Smart curve for fan controls. Each PWM fan can be set to a separate fan curve.
To set a Smart curve, please see the guide starting at the top of the next page.
The +/- buttons next to Smart allow you to set your fans at a static speed percentage,
instead of a curve. If you set the speed too low, however, the fan may stall; the stall
speed will vary from fan to fan.
Below the fans, you will see the four (4) DC fans: SYS1_FAN, SYS2_FAN, PWR_FAN,
and AUX_FAN. These fans can only be set to a static speed percentage. Again, if you
set the speed too low, however, the fan may stall; the stall speed will vary from fan to
fan.
The DC/PWM fan headers can be set to either DC Mode or PWM Mode, which can be
selected by clicking on the pulldown menu. DC Mode will power the header using the
static percentage set and the fan's maximum speed. PWM Mode will power the header
and communicate via PWM with a supported PWM fan. PWM mode is necessary if you
are running a PWM fan powered by a different connector, such as a molex, SATA, or 3-
pin header not on the motherboard. If you don't select PWM mode in this scenario, the
fan may run at 100%, or behave erratically, regardless of the static percentage you set
above. If you have a PWM fan powered directly by the 4-pin header, then selecting
PWM will control the fan via PWM signal NOT via reducing voltage, while it will run at
a static speed based on the percentage selected, this also should reduce the low RPM
stall point of the fan as it is receiving full voltage. A DC fan will run at its static
percentage regardless of whether you set DC Mode or PWM Mode.
To set a Smart curve, select the "Smart Fan Settings" and enter the menu.
- 97 -