Ipv6 Firewall - D-Link DIR-808L User Manual

Section 3 - Configuration
The DIR-808L's IPv6 firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device.
The DIR-808L's IPv6 firewall functions in a similar way to the IP Filters feature.
Enable.IPv6.
Tick the box to enable ingress filtering protection for IPv6.
Ingress.Filtering:
Enable.IPv6.
Check the box to enable the IPv6 firewall simple security.
Simple.Security:
Configure.IPv6.
Select an action from the drop-down menu.
Firewall:
Name:
Enter a name to identify the IPv6 firewall rule.
Schedule:
Use the drop-down menu to select the time schedule that the
IPv6 firewall rule will be enabled on. The schedule may be set
to Always, which will allow the particular service to always
be enabled. You can create your own times in the Tools >
Schedules section.
Interface.(Source):
Use the drop-down menu to specify the interface that connects
to the source IPv6 addresses of the firewall rule.
IP.Address.Range.
Enter the source IPv6 address range in the adjacent IP.Address.
(Source):
Range field.
..Protocol:
Select the protocol of the firewall port (All, TCP, UDP, or ICMP).
Interface.(Dest):
Use the drop-down menu to specify the interface that connects
to the destination IP addresses of the firewall rule.
IP.Address.
Enter the destination IPv6 address range in the adjacent IP.
Range.(Dest):
Address.Range field.
Port.Range:
Enter the first port of the range that will be used for the firewall
rule in the first box and enter the last port in the field in the
second box.
D-Link DIR-808L User Manual

IPv6 Firewall

101