Remote Start/Stop; Valet Modes - AstroStart DSP621 Owner's Manual

Remote Start/Stop

Press and release
Activate the remote starter. The engine and parking lights turns on and the 2-way
remote control confirms the activation by text, icon and tone. or the engine and
parking lights turn off and then the 2-way remote control will update to confirm
shutdown.
Press and hold the
The parking lights turns off and the 2-way remote control confirms by using text,
icon and tones.
If the remote start fails to turn on, the remote control will display an alert by text,
icon, or tone, and the vehicle parking lights will flash to indicate the cause. Refer
to the following table for the likely cause.
Alert Conditions:
Parking Light
Flashes
5
6
7
9

Valet Modes

Remote Valet Modes
The Valet commands in the remote command table turn on/off the Alarm Valet,
Start Valet, or Combo Valet Modes (both Alarm & Start Valet).
• Alarm Valet ( +
The Alarm Valet mode will disable included alarm features when armed/
locked. It also disables any passive arm/lock settings if programmed on.
The 2-way remote control confirms by using text, icon, or tones.
• Start Valet (
The Start Valet mode will disable remote start features until turned off. The
2-way remote control confirms by using text, icon, or tones.
14
icon for at least 4 seconds to remotely stop the engine.
Possible Cause
Brake ON
Hood Open
After performing Remote Start
command MTS not enabled.
Start Valet on
)
)
+
Solution
Release Foot Brake.
Close Hood.
Enabled MTS Mode.
Turn Start Valet off
© 2017 Directed. All rights reserved.