Start Commands - AstroStart QS-5 User Manual

START COMMANDS

STARTING THE ENGINE
To start the engine, press "
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once
(duration: four seconds) then stay on all the time engine is running.
If more than one command is emitted, each successive start command resets runtime to the beginning,
parking lights flash once to confirm command has been received and horn sounds once to let you know
engine is already running.
Repeating this command will produce an audible (horn) confirmation that engine has started, which can be
useful if vehicle is not in sight.
I
F ENGINE FAILS TO START
If your remote control system cannot start your engine at first attempt, it will wait for a few seconds and
then try again (it could try again twice depending on reason for failure to start).
After three attempts, it will shut down automatically and wait for new command (see "Start fail Codes" on
page 9).
U
PON ENTERING YOUR VEHICLE
Do not apply brakes; this will stop engine immediately.
Insert ignition key and turn it to "ON" position.
Drive as usual.
E
NGINE RUNTIME
Your engine will stop automatically after a preset time. Parking lights will stay on as long as engine is
running. Engine runtime is programmable.
T
RIGGER INPUT
Your remote starter is equipped with a negative trigger (pulse) input.
This input can be connected to another remote control device or to a
timer output (optional).
If this input is connected, consult this device's manual or ask your
technician which command controls the start/stop function.
The start/stop commands received on this input are ignored while the
engine is running on a remote start.
All Start/Stop functions controlled by this input behave in the same
way as functions controlled by remote.
" button (horn: 0, lights: 1).
...
DO NOT TURN THE IGNITION KEY TO THE
"START"
POSITION.
QS-5
5