Start Commands - AstroStart RS-213 User Manual

RS-213 COMMAND CODES
Command
Start/stop
Lock
Unlock
Trunk release
Sentinel mode
Start only
Car finder
Controlled output
Channels 2,3 and 4 on 4-button remote are not used on RS-213.
Confirmation of these three commands can be programmed as ACTIVE or INACTIVE
during installation. When programmed as INACTIVE, there is no confirmation.
* Function "B" on 2-button remote control corresponds to command "A&B".
* Function "A&B on 2-button remote control corresponds to command "A&C".
Shaded areas correspond to
options that can be programmed
during installation. A maximum of
two of these commands can be
selected; see option list opposite.
"Car finder" and "Controlled
output" functions can be allocated
to either of A&B or A&C
commands depending on
available options.
Option 1 is programmed at factory. Ask your dealer if this option was changed during

START COMMANDS

STARTING AND STOPPING YOUR ENGINE
To start your engine, enter command from table (horn: 0, lights: 1). System
automatically sets ignition contact time depending on your vehicle. Parking lights will
stay on all the time engine is running.
To stop engine, enter same command.
Trigger input
Your Remote Starter is equipped with a negative trigger input. This input can
be connected to another remote control device or timer output. If this input is
connected, consult device manual or ask your technician which command is
associated with start/stop function. All start/stop functions controlled by this
input operate in same way as input controlled by remote control.
1 BT 2 BTS
A
B *
A&B *
Controlled output
Controlled output
installation and if so, check
3 BTS
A A
B
C
B&C
A&B
A&C
A&B / A&C
A&B / A&C
A&B
Sentinel
Sentinel
Sentinel
Car finder
appropriate box.
RS-213
4 BTS Confirmation
1A Lights
1B Lights
1C Lights
1B&C Lights
1A&B Lights
1A&C Lights,
A&B / A&C Lights,
A&B / A&C Lights
A&C
Start only
Controlled output
Car finder
Start only
Car finder
Start only
horn
horn
3