Start Commands; Starting And Stopping Your Engine - AstroStart RS-113 User Manual

RS-113 COMMAND CODES
Command
Start/stop
Activate Antitheft
Lock
Deactivate Antitheft
Unlock
Trunk release
Sentinel mode
Start only
Car finder
Controlled output
Channels 2,3 and 4 on 4-button remote are not used on RS-113.
Confirmation of these commands can be programmed as ACTIVE or INACTIVE
during installation. When programmed as INACTIVE, there is no confirmation.
* Function "B" on 2-button remote control corresponds to command "A&B".
* Function "A&B on 2-button remote control corresponds to command "A&C".
Shaded areas correspond to options
that can be programmed during
installation. A maximum of two of
these commands can be selected;
see option list opposite. "Car finder"
and "Controlled output" functions
can be allocated to either of A&B or
A&C commands depending on
available options.
Option 1 is programmed at factory. Ask your dealer if this option was changed during

START COMMANDS

STARTING AND STOPPING YOUR ENGINE

To start your engine, enter command from table (horn: 0, lights: 1). System
automatically sets ignition contact time depending on your vehicle. Parking lights will
stay on all the time engine is running.
To stop engine, enter same command.
1 BT 2 BTS
A
A&B *
installation and if so, check
3 BTS
A A
B
B
C
C
B&C
B * A&B
A&C
A&B / A&C
A&B / A&C
A&B
Sentinel
Sentinel
Sentinel
Controlled output
Controlled output
Car finder
appropriate box.
4 BTS Confirmatio
n
1A Lights
1B Lights
1B Lights
1C Lights
1C Lights
1B&C Lights
1A&B Lights
1A&C Lights, horn
A&B / A&C Lights, horn
A&B / A&C Lights
A&C
Start only
Controlled output
Car finder
Start only
Car finder
Start only
5