Furuno VR3000 Instruction Manual page 46

Initialize the DRU as follows (Direct connection):
1. Start Live Player V4 software.
2. Open the Tool menu and select Source Select. Select Live from the pull-down
menu.
3. Click the Alarm tab and open Alarm History.
4. Set the Playback/CPU switch in the DCU to the Playback position.
5. Wait approx. 10 minutes and confirm that Alarm 174 occurs on Alarm History of Live
Player V4.
6. Connect an IEEE1394 cable between J6 in the DCU and the PC.
7. Open the Tool menu.
8. Select Media Management to open the VDR Media Management window.
9. Select Direct in the VDR Media Table window.
10. Click the Analyze button. A list of recording media connected to the VDR appears.
11. Put a checkmark in the box of the Select column for the DRU and the desired
recording media in the Name column. In the Operation dropdown list of the Operation
area, select "DRU Creation".
12. Enter password in the password column.
13. Click the Run button.
Initialize the Backup HDD as follows (Direct Connection):
1. To format the Backup HDD, place a checkmark in the Select column of the listed
record media in the Name column of the VDR Media Management dialogue box.
2. From the Operation column of the Operation area, select "Backup HDD Creation
(Radar) or "Backup HDD Creation".
Backup HDD creation：
This tool is used when the number of the SXGA video signal connected to the Backup
HDD is the same as the DRU. The same partition is created on both DRU and HDD.
(1) When two SXGA video signals are recorded onto the HDD while 9-GB DRU is
connected.
(2) When an SXGA video signal is recorded onto the HDD while 6-GB DRU is
connected
Backup HDD creation (radar)：
This tool is used when two SXGA video signals are recorded onto the HDD with 6-GB
DRU connected. The HDD has an area (radar) to record the second radar signal in
addition to the same partition as the DRU. This tool cannot be used when 9-GB DRU
is connected.
3. Enter the password in the Password column.
4. Press the Run Button.
44