Furuno VR3000 Instruction Manual page 14

Items are as follows:
Active:
Brand:
Type No.:
Check:
Data Name:
Horizontal resolution:
Vertical resolution:
Horizontal Offset:
Vertical offset:
PLL:
CDEV:
VCOSL:
Phase (0-63):
Sync Type:
Horizontal sync polarity: Set the polarity of the horizontal sync signal.
Vertical sync polarity:
HD/VD Sync Termination: Sets horizontal and vertical synchronization point. When
Pulse Width for VD Detection (0-1020 Step4): Sets the pulse width for video signal
Interlace Type:
Check a channel to activate it.
Enter brand name.
Enter type no.
Set and activate check.
Enter data name.
Set horizontal resolution.
Set vertical resolution.
Move the picture horizontally.
Move the picture vertically.
This sets the frequency of the PLL-oscillator.
Set CDEV.
Set VCO Signal Lead.
Phase setting selects the phase of the sampling clock relative
to phase locked loop signal, in 64 steps of 5.625 degrees. If
Phase is not set correctly, any section of an image consisting
of vertical lines may show line "tearing".
Select the type of video sync signal.
Set the polarity of the vertical sync signal.
using a composite signal, set to 75ohms.
detection.
When the video image is interlace, set "Interlace" sampling
mode. In Interlace mode, the even pixels are sampled on one
frame and odd pixels are sampled on the other frame.
12