Safety Screen Replacement; Accent Light Bulb Replacement - HAMPTON BAY H15-NG10 Owners & Installation Manual

SAFETY SCREEN REPLACEMENT

1. Turn off stove and allow to return to room temperature.
2. Lift off cast top and place on a soft surface.
3. Remove 2 bolts and lift off cast front - place front carefully on a soft surface.

ACCENT LIGHT BULB REPLACEMENT

1. Turn off stove and allow to return to room temperature.
2. Shut off electrical supply
3. Lift off cast top and place on a soft surface.
4. Slide the light assembly bracket out of the way.
5. Loosen 4 screws in locations shown below to release safety screen frame.
6. Slide safety screen to one side to remove.
7. Replace screen and reverse steps to reinstall.
4. Loosen bolts securing cast front–slide light assembly bracket upward to
release.
5. Remove one (1) screw to remove bulb housing.
Lift light assy bracket off bolts to replace bulb
Remove one screw in location shown
6. Replace bulb.
Note: Oils from hands will shorten the life of the bulbs,
do not handle bulbs with bare hands.
7. Reverse steps to reinstall.
Hampton® H15-10 Direct Vent Freestanding Gas Stove
maintenance
|
43
| 43