Table of Contents
Advertisement
OPTIONAL FAN
OPTIONAL FAN
INSTALLATION
INSTALLATION
1.
Remove the rear access panel on the back of
the stove by removing 2 bolts at the bottom of
the panel. Lift panel up and away to remove.
bolt
Lift Rear Panel off of the 2 top bolts.
2.
Place a grommet on wiring from fan to be plugged
into the receiver.
919-523a
3.
Remove left side access panel (when
facing front) by removing one screw.
4.
Undo wire clip to release red and black
fan wires. Remove cap ends from the
wire spades and plug in fan wires - black
to black and red to red.
Cap ends
Thermostat (Optional)
(Millivolt)
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this plug.
installation
5.
Tuck the fan assembly in behind the legs
as shown. On either side of the unit there
will be slits located on the body of the
stove. Slide the fan up into the slits until
the mounting holes line up with the holes
located on the fan assembly. Secure with
one screw per side (leave right side screw
loose).
6. Eliminate any slack from fan wire by
pulling into the unit and securing with
wire clip.
7.
Tighten screw on right side.
8.
Reinstall back access panel.
9. Plug the fan into the nearest outlet
10. To remove fan - reverse steps.
Hampton® H15-10 Direct Vent Freestanding Gas Stove
H15
|
11
04.01.15
|
11
Hide quick links:
Advertisement
Table of Contents
