Checking Sliding Table Extension; Installing Blade Guard - RIDGID TS2400 Owner's Manual

Checking Sliding Table Extension

Lock the table extension lock lever. Pull-push on the slid-
ing table extension. It should resist moving.
WARNING: To reduce the risk of thrown workpiece,
do not use with extension lock lever unlocked.
If the sliding table extension moves when locked:
1. Release the table extension lock lever.
2. Find the front hex coupling located underneath the
front table.
3. Loosen the hex locking nut.
4. Turn the hex coupling counterclockwise.
5. Lock the table extension lock. Pull-push on the sliding
table extension. Readjust hex coupling if necessary.
Tighten the hex locking nut against coupling.

Installing Blade Guard

1. Locate the blade guard.
2. Two (2) locator pins are on the blade guard. These
locator pins fit into matching holes on a bracket located
on the table saw trunnion.
3. Turn the blade guard locking knob clockwise to
securely attach the blade guard in place.
Front Hex
Coupling
Blade Guard
Locking Knob
21
Hex Locking
Nut
Pin