Table Extension - RIDGID R4120 Operator's Manual

ASSEMBLY
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional
so that we can clearly show points being made in the
illustrations. Never operate the saw without all guards
securely in place and in good operating condition.

TABLE ExTENSION

See Figure 9.
The table extension can be used on the left side of the miter
saw. To assemble and install the table extension:
 Insert socket head screw and washer into the two holes
in the side of the miter saw base.
 Lay a framing square flat on the table extension and saw
base. Place the square against the fence on the table
extension and the fence on the saw base.
 When the table extension and saw base are level and
both fences in alignment, tighten screws securely.
DUST GUIDE
See Figure 10.
Insert the dust guide inside the exhaust port in the upper
blade guard. Turn the guide so that the open end is facing
down or toward the rear of the saw.
table
extension
washer
soCket heaD
sCrew
upper
blaDe guarD
Dust
guiDe
exhaust
port
15
work ClaMp
hole
washer
Fig. 9
Fig. 10