Ridgid Recommends The Following Accessories; Troubleshooting; General - RIDGID TS2400 Owner's Manual

RIDGID Recommends the Following Accessories

Item
Molding/Dado Insert for 7" Dia. Molding .........................
or Dado Head......................................................AC1025
Molding/Dado Insert for 8" Dia. Molding .........................
or Dado Head......................................................AC1030
Table Saw Miter Gauge Hold Down Clamp........ AC1022
Universal Power Tool Legset ............................. AC9910

Troubleshooting

WARNING: For your own protection, turn switch "OFF" and always remove plug from power source outlet
before troubleshooting.

General

Trouble
Excessive Vibration
Cannot make square
cut when crosscutting.
Cut binds, burns or
stalls motor when rip-
ping.
Cut not true at 90° or
45° bevel positions.
Elevating handwheel
turns hard.
SKU No.
Probable Cause
1. Blade out of balance or damaged 1. Replace blade.
1. Miter gauge not adjusted prop-
erly.
1. Dull blade or improper tooth set.
2. Blade is heeling.
3. Warped board
4. Rip fence not parallel to blade.
5. Spreader out of alignment.
1. Indexes not properly adjusted.
1. Sawdust on threads of elevating
screw.
Do not use any accessory unless you have received and
read complete instructions for its use.
WARNING: Use only accessories recommended for
this saw. Using other accessories may be danger-
ous.
1. See "Adjustments" section "Miter Gauge."
1. Sharpen or replace blade.
2. See "Alignment" section, "Heeling Adjustment".
3. Make sure concave or hollow side is facing "down"
feed slowly.
4. See "Alignment" section, "Aligning Rip Fence."
5. See "Alignment" section, "Installing Blade Guard."
1. See "Alignment" section, "Blade Tilt, or Squareness
of Blade to Table".
1. See "Maintenance" and "Lubrication" sections.
43
Remedy