Display And Debug Device Management; System Maintenance And Debugging; Configuring System Basics - 3Com 7700 Configuration Manual

14 C 11: S
HAPTER YSTEM
Display and Debug
Device Management
System Maintenance
and Debugging
Configuring System
Basics
M
ANAGEMENT
Set backboard view
The backboard view command determines the backplane bandwidth allocated to
each slot in the Switch 7700. Currently, the Switch Fabric has the capability of
32Gbpos full duplex yet the chassis has a maximum capability of 48 Gbps full
duplex. This command sets the bandwidth available to each slot in the system.
Perform the following configuration in system view.
Table 26 Set Back Board View
Operation
Set back board view
[SW7700]set backboard view INTEGER<0-5>
MOD1
0: 8G,
1: 8G,
2: 8G,
3: 8G,
4: 8G,
5: 8G,
The default setting is 1 (8G to slots 1 and 2, 4G to slots 3-6)
After the above configuration, execute display command in all views to display
the device management configuration, and verify the effect of the configuration.
Table 27 Display and Debug Device Management
Operation
Display the set back board view.
Display the module types and
running states of each card.
Display the running state of the
built-in fans.
Display the information about the
environment.
Display the used status of switch
memory.
Display the state of the power.
This section includes descriptions of the following types of system maintenance ad
debugging:

Configuring System Basics

■
Display the State and Information of the System
■
System Debugging
■
This section describes the following basic system configuration tasks:
Setting the System Name
■
Command
set backboard view value
MOD2 MOD3
8G, 8G,
8G, 4G,
8G, 8G,
8G, 8G,
8G, 6G,
8G, 6G, 4G,
Command
display backboard view
display device [ detail | [ shelf shelf-no ] [ frame
frame-no ] [ slot slot-no ] ]
display fan [fan-id]
display environment
display memory [ slot slot-number ]
display power [ power-ID ]
MOD4 MOD5 MOD6
8G
4G, 4G,
4G, 4G
6G, 2G
6G, 2G,
4G, 2G
4G
2G