3Com 7700 Configuration Manual page 308

28 C 11: S M
HAPTER YSTEM ANAGEMENT
Perform the following configuration in system view.
Table 51 Set the Engine ID of a Local or Remote Device
Operation
Set the engine ID of the device
Restore the default engine ID of the
device.
By default, the engine ID is expressed as enterprise No. + device information. The
device information can be IP address, MAC address, or user-defined text.
Setting and Deleting an SNMP Group
You can use the following commands to set or delete an SNMP group.
Perform the following configuration in system view.
Table 52 Set/Delete an SNMP Group
Operation
Setting an SNMP group
Deleting an SNMP group
The authentication parameter specifies that the packet is authenticated without
encryption. This parameter is supported only in SNMP V3.
The privacy parameter specifies that the packet is authenticated and encrypted.
This parameter is supported only in SNMP V3.
Setting the Source Address of the Trap
You can use the following commands to set or remove the source address of the
trap.
Perform the following configuration in system view.
Table 53 Set the Source Address of the Trap
Operation
Set the Source Address of Trap
Remove the source address of trap undo snmp-agent trap source
Adding and Deleting a User to or from an SNMP Group
You can use the following commands to add or delete a user to/from an SNMP
group.
Command
snmp-agent local-engineid engineid
undo snmp-agent local-engineid engineid
Command
snmp-agent group group-name { v1 | v2c } [ read-view
read-view ] [ write-view write-view ] [ notify-view
notify-view ] [ acl acl-list ]
snmp-agent group group-name v3 [ authentication |
privacy ] [ read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl acl-list ]
undo snmp-agent group group-name { v1 | v2c }
undo snmp-agent group group-name v3 [
authentication | privacy ]
Command
snmp-agent trap source interface-name interface-num