ATN ThOR-HD 384 2 - 8x User Manual page 22

Although you may not need to take more then one shot to zero in your
scope, we do recommend that you repeat the process several times to
make sure that you truly are zeroed in. As you gain experience in zeroing
in your scope, it should take you no time before you are experienced at
zeroing out your scope.
22
NOTE
You will need to obtain
a target which thermal is
able to see. ATN sells Ther-
mal Targets, or you can
use any of the following
items: Cold or Hot water
bottle, hand warmers, or
foil based tape.
To zero your rifle with the
ATN device, you should
follow the next few steps.
In the System Settings,
Select the Profiles/Zero
Tab. The main Subcate-
gories of the Profiles/Zero
are; Current, Other, Import
from SD card, and Export to
SD card. Select Current, by
pressing the ENTER button
. There you will see Zero
Reticle. We suggest you fill
out all the ballistic info to the
best of your ability before
proceeding to Zero. This
will save you time when
you want to use the Ballistic
Calculator at a later time.
Proceed to Zero the Ret-
icle. Press the EN T ER
button to select Zero
Reticle. You will see on
your screen a cross hair
reticle. While keeping the
gun as steady as possible,
fire a round. Use the key
pad to move the Red cross
hair to the point of impact,
while keeping the White
crosshair in the same place
you where aiming. Once
you have placed the Red
crosshair on the POI press
the ENTER button. A dia-
logue box will appear with
options. Select Save & Exit.
NOTE