Lighting The Heat Pure; Lighting The Heat Pure For The First Time - KAL-FIRE 45 Installation And User Manual

5

Lighting the Heat Pure

5.1

Lighting the Heat Pure for the first time

Lighting the Heat Pure for the first time
When the Heat Pure is lit for the first time, the enamel on the stove will When the Heat Pure is lit for the first time, the enamel on the stove will
burn in and cure. This causes nuisance in the form of odour and fumes.
Make sure the room is well ventilated. It is advisable to light the Heat Make sure the room is well ventilated. It is advisable to light the Heat
Pure during the day, and open all doors and windows in order to reduce Pure during the day, and open all doors and windows in order to reduce
the odour nuisance. After five fires at the most, any odours should
completely disappear.
Specific instructions for fireplaces with painted panels Specific instructions for fireplaces with painted panels
Paint in the interior of the fireplace will harden after being Paint in the interior of the fireplace will harden after being
heated in the first lighting of a fire. Thus it is important that the heated in the first lighting of a fire. Thus it is important that the
first fire burns moderately, using no more than 2 kg of wood.
Leave the fire burning for at least 2½ hours, and then allow the Leave the fire burning for at least 2½ hours, and then allow the
appliance to cool off completely (see instructions below). This appliance to cool off completely (see instructions below). This
allows the optimal curing of the paint.
The first time the paint inside the fireplace is heated it becomes The first time the paint inside the fireplace is heated it
soft and sticky. Avoid touching any painted components. After soft and sticky. Avoid touching any painted components. After
the first fire, leave the glass door open about 5 cm, closing it the first fire, leave the glass door open about 5 cm, closing it
only after the Heat Pure has completely cooled off. If the glass only after the Heat Pure has completely cooled off. If the glass
adheres to the paint on the frame, tilt it forward to ensure the adheres to the paint on the frame, tilt it forward to en
glass is not in contact with the frame (see section 5.2). glass is not in contact with the frame (see section 5.2).
nuisance in the form of odour and fumes.
After five fires at the most, any odours should
33
5. Lighting the fireplace 5. Lighting the fireplace
re than 2 kg of wood.