Table of Contents
Advertisement
3.7
Mounting the damper
The Heat Pure is delivered as standard without a damper. A damper can
be used to influence the degree of draught (suction) in the flue. With the
Heat Pure an external damper can be added. If there is too much suction
in the flue, we advise you to use a damper. The amount of draught can
be tested when you ignite the fire to test the operation of the appliance.
Pay extra attention to this aspect, if the flue is longer than 7 metres.
Normally the Heat Pure can be controlled well using the air regulation
(see section 5.3).
Attention
Make sure that the position of the damper is visible for the end user.
•
For this purpose most of the operating knobs have a position
indication (Open = Auf or + , Closed = Zu or -).
Check the functioning of the damper before completing the
•
installation of the Heat Pure.
Make sure that the end user is familiar with way the damper
•
functions.
3.8
Adjusting the feet
Rough adjustment
Unscrew the two bolts and roughly
set the height.
Range 38 cm. Do not forget to
place the two bolts back.
3. Mounting and installation
Fine adjustment
Screw the adjustment foot bolt to
set the precise height. Range 5 cm.
Use this method to set the Heat
Pure perfectly level.
22
Hide quick links:
Advertisement
Table of Contents
