Table of Contents
Advertisement
7. Enter the following command:
where:
• <interface_str> is the name of the network interface, such as port1
• <address_ipv4> is the IP address of the network interface, such as 192.168.1.10
• <mask_ipv4> is the netmask of the network interface, such as 255.255.255.0
Enter the following command:
where:
• <interface_str> is the name of the network interface configured in the previous step,
• <accessmethods_str> is a space-delimited list of the administrative access protocols
The network interface's IP address and netmask is saved. You can now reconnect to either
the web UI or CLI through that network interface. For information on restoring the
configuration, see
Restoring the configuration
You can restore a backup copy of the configuration file from your local PC using either the
web-based manager or CLI. For information about configuration backup, see
configuration" on page
If you have just downgraded or restored the firmware of the FortiVoice Gateway, restoring the
configuration file can be used to reconfigure the FortiVoice Gateway from its default settings.
To restore the configuration file using the web UI
1. Clear your browser's cache. If your browser is currently displaying the web-based manager,
also refresh the page.
2. Log in to the web-based manager.
3. Go to System > Maintenance > Configuration.
4. Under Restore Configuration, click Browse to locate and select the configuration file that you
want to restore, then click Restore.
The FortiVoice Gateway restores the configuration file and reboots.Time required varies by
the size of the file and the speed of your network connection.
5. After restoring the configuration file, verify that the settings have been successfully loaded.
For details on verifying the configuration restoration, see
page
To restore the configuration file using the CLI
1. Initiate a connection from your management computer to the CLI of the FortiVoice Gateway,
and log in as the admin administrator, or an administrator account that has system
configuration read and write privileges.
2. Connect a network interface of the FortiVoice Gateway directly or to the same subnet as a
TFTP server.
3. Copy the new firmware image file to the root directory of the TFTP server.
Fortinet Technologies Inc.
set system interface <interface_str> mode static ip <address_ipv4>
<mask_ipv4>
set system interface <interface_str> config allowaccess
<accessmethods_str>
such as port1
that you want to allow on that network interface, such as ping ssh https
"Restoring the configuration" on page
41.
60.
Page 59
FortiVoice Gateway 5.3.6 Administration Guide
59.
"Backing up
"Verifying the configuration" on
Advertisement
Table of Contents
