Adjusting Input Levels Manually - Planar WN-5040-720 User Manual

3.2 Adjusting Each Margay To Its Source

3.2.1.1 Adjusting Input Levels Manually

It is rarely necessary to adjust input levels manually. You can skip this section.
Adjusting levels manually
1. Display an all-black picture from the source com-
puter.
2. Press on the remote.
LEVEL
3. Select M B
ANUAL LACK
down with the +/– keys to make the three C
P values go to zero. If they do not all touch
OINT
zero at the same time, use the individual colors
under M B
ANUAL LACK
Do not go beyond the point where the Minimum just
goes to zero. The idea is to just touch the zero level.
4. Display an all-white picture from the source com-
puter.
5. Select M W
ANUAL HITE
until the C P
ENTER OINT
adjusting the individual colors as necessary.
It is not a good idea to use the levels to make all the
displays in a wall match each other. That should be
done with the Color Balance menu. ("Color Balancing a
Wall of Margays" on page 52.)
46
L and adjust it up and
EVEL
ENTER
L to adjust them.
EVEL
L and adjust the levels
EVEL
values just touch 255,