Planar WN-5040-720 User Manual page 94

LED Name
Lamp is on (or no
Ready
Source Source absent
Lamp Lamp off
Fan Fan off
Remote IR Not receiving IR now
Door Open (refers to
No power to electron-
rear panel and elec-
tronics module door)
Serial Data
No command received
Serial Cmd
Lamp Saver not active
Lamp Saver
Optical Engine Status
1
Lamp off
Ballast Status
2
High voltage (HV) off
Ballast Supply
1. At this writing, Ballast Status LED is not implemented, so it is always off.
2. At this writing, Ballast Supply LED will show Red state only briefly.
LEDs in Margay
Off
power)
Valid source present
Lamp on
Fan is running
Receiving IR radiation
Door closed & rear
panel closed
ics
Lamp enabled
Received any com-
mand
Received command
"meant for me"
Lamp Saver active
Source present
or lamp is off
Lamp on
Optical engine OK
Lamp on
HV on and ready
When the LED is...
Green Amber
Lamp striking
Fan failed recently, but
is now running
Either door was open,
now closed
Must cycle AC power
to reset and enable
lamp
Active
Lamp is cooling
Source present
Lamp will come on
when cooled
HV on but not ready
Red
Source absent or not
valid
Lamp failed
Fan failed
Lamp disabled
Either door open
Lamp disabled
Active
Source absent
Lamp off
Optical engine fault or
communication fail-
ure
Ballast fault or com-
munication failure
Had to wait more than
10 seconds for ready
state
83