Installation Procedure
Optional: For the installation of
the circular panel
Making a circular opening on the ceiling
Use a paper compass printed on the indoor unit package.
(attached inside to the upper part)
1 Use a bolt or a pin to fix pivot point of the paper
compass on center of the ceiling. (in the middle of
location for installation)
2 Put a pencil at the opposite side of the pivot point
fixed in place.
3 Rotate the paper compass on its pivot point to draw a
line on the ceiling.
34
English
4 Rotate the paper compass diametrically to draw a
circle on the ceiling.
For the painting of the panel
Make sure to only apply paints and varnishes for
resins (ABS, HIPS) or paint thinners.
If you apply lacquers for general use on the panel, it
may lead to discoloration or erosion on the surface of
the panel.
Optional: Installing DPM (Digital
Packaged Multi)
NOTE
Only AC071MN4PKH, AC100MN4PKH and
AC120MN4PKH models are available to install DPM.
When installing DPM, you should set "DPM setting" to
the outdoor unit.
You do not need to set the address manually for the
indoor unit.
If DPM model is not set, communication error may
occur.
While the outdoor unit is tracking the indoor unit for
one minute after the power supply is turned on, the
operation may stop if the remote control reception
signal of the installed indoor unit is different.
To enable Level contol with the centralized controller,
refer to page 32, 33.
CAUTION
When installing DPM, only one external controller can
be connected.