Samsung AC071MN4PKH Installation Manual page 24

Installation Procedure
b Set the SEG24 value by rotating the Wheel clockwise
until the value you want to set appears on the remote
control display.
When you rotate the Wheel, values appear in the following order:
3 Check whether the option values that you have set are
correct by pressing the
[SEG2, SEG3] [SEG4, SEG5]
[SEG11, SEG12] [SEG14, SEG15]
[SEG21, SEG22] [SEG23, SEG24]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it
is successfully received, you can hear a short sound
from the indoor unit. If the command is not received,
press the (Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor or outdoor unit.
Indoor unit : Press the
buttons on the remote control simultaneously for
4 seconds.
Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control,
insert them again, and then press the
button on the remote control.
24
English
Steps
(Mode) button repeatedly
[SEG6, SEG8] [SEG9, SEG10]
[SEG16, SEG17] [SEG18, SEG20]
(Power)
(Set) and (Option)
(Power)
MR-EC00 and MR-EH00 remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
NOTE
The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
Remote control display
SEG24
Setting the
option values
Mode button
High Fan button
Low Fan button
(High Temp) and