Assembly; Operation - Porter-Cable 7335 Instruction Manual

NOTE: This tool is shipped completely assembled. No assembly time or
tools are required.
AUXILIARY HANDLE
An auxiliary handle (A) Fig. 1 is
furnished with the tool. You can
install the auxiliary handle on either
side of the front housing to facilitate
either right-handed or left-handed

operation.

Use this handle at all times to maintain complete control
of the tool.
TO START AND STOP TOOL
Make certain that the switch is in the "OFF" position, and the
power source is the same as that specified on the tool's nameplate.
1. Connect the tool to the power
source.
2. Slide the switch button (A) Fig.
2 forward to start the motor.
Slide the switch button to the
rear to stop the motor.
VARIABLE SPEED MODELS
Adjust the speed by turning the
thumbwheel (A) Fig. 3. Thumb-
wheel position #1 provides the
slowest operating speed (2500
OPM) and position #6, the fastest
(6000 OPM). You can change the
speed while the motor is running or
while it is stopped.

ASSEMBLY

Fig. 1
OPERATION
A
10
A
Fig. 2
A
Fig. 3