Assembly And Adjustments; Operation - Porter-Cable PCCW201 Instruction Manual

English
THIS PRODUCT USES THE BATTERY
AND CHARGER LISTED IN THE
CHART BELOW.
Description
20V Max* lithium-ion
Battery
20V Max* lithium-ion
Battery Charger

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Attaching hook and loop sanding sheets
(Fig. B)
For best results, use PORTER-CABLE accessories.
• To attach the sanding sheet
over the sanding pad 5 ensuring the holes in the disc align
with the holes in the pad and press the sheet firmly in place.
• The hook and loop fastening system sanding sheet
can be easily removed by simply pulling it off. It can be
reused as desired.
Fig. B
10
5
Sanding Sheet Tips (Fig. C)
• Detach the two additional diamond-shaped tips
from the sanding sheet
10
note: The diamond-shaped tip
replaced when worn.
• When the front part of the tip
the sheet, reverse it and press it onto the diamond-shaped
pad tip again.
13
8
Catalog number
ʵ PCC680L
ʵ PCC681L
ʵ PCC682
ʵ PCC682L
ʵ PCC685L
ʵ PCC690L
ʵ PCC691L
ʵ PCC692
ʵ PCC692L
ʵ PCC695L
ʵ PCC699L
ʵ PCCB122
10 , carefully center the sheet
11
.
can be reversed and
11
11 is worn, detach it from
• When the whole tip is worn, remove it from the sanding
base and fit a new tip.
nOTE: For optimal dust collection, ensure the correct type
of sanding paper is used.
Fig. C
13
Replacing diamond shaped pad tip (Fig. D)
1. Remove the screw 14 and remove the diamond-
shaped pad tip 13 .
2. Rotate tip to unused side and tighten screw
Finger Attachment
(Fig. D - Optional accessory)
The finger attachment is used for fine detail sanding.
1. Remove the screw 14 .
2. Remove the diamond-shaped pad tip
3. Fit the finger attachment
shown in Figure D.
4. Fit and tighten the screw.
5. Align the appropriate sanding sheet with the
finger attachment.
Fig. D
6

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
11
10
14 .
13 from the base.
6 onto the sanding base as
14
13