Intended Use; Operation; Assembly And Adjustments - Porter-Cable PCCW205 Instruction Manual

English
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part of
it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

INTENDED USE

Your PORTER-CABLE random orbital sander has been
designed for sanding wood, metal, plastics and painted
surfaces. This product is intended for household, consumer
use only.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
THIS PRODUCT USES THE BATTERY
AND CHARGER LISTED IN THE CHART
BELOW.
Description
20V Max* lithium-ion
Battery:
20V Max* lithium-ion
Battery Charger:

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Attaching hook and loop sanding
discs (Fig B.)
Your sander is designed to use 5" (127mm) sanding discs
with the 8 hole dust extraction pattern. For best results, use
PORTER-CABLE accessories.
• To attach the sanding disc
sanding pad 3 ensuring the holes in the disc align with
the holes in the pad and press the disc firmly in place.
The hook and loop fastening system sanding disc can be
easily removed by simply pulling it off. It can be reused as
desired.
8
Catalog Number
ʵ PCC680L
ʵ PCC681L
ʵ PCC682
ʵ PCC682L
ʵ PCC685L
ʵ PCC690L
ʵ PCC691L
ʵ PCC692
ʵ PCC692L
ʵ PCC695L
ʵ PCC699L
ʵ PCCB122
8 , carefully center it over the
Fig. B
8
3

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C, D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 7 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
Fig. D
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
into the tool handle, align the
6
6
7