HP 12500 Series Configuration Manual page 92

# Configure Switch C.
[SwitchC] mpls lsr-id 3.3.3.3
[SwitchC] mpls
[SwitchC-mpls] mpls te
[SwitchC-mpls] quit
[SwitchC] interface vlan-interface 2
[SwitchC-Vlan-interface2] mpls
[SwitchC-Vlan-interface2] mpls te
[SwitchC-Vlan-interface2] quit
Configure an MPLS TE tunnel.
4.
Configure an MPLS TE tunnel on Switch A.
[SwitchA] interface tunnel 0
[SwitchA-Tunnel0] ip address 6.1.1.1 255.255.255.0
[SwitchA-Tunnel0] tunnel-protocol mpls te
[SwitchA-Tunnel0] destination 3.3.3.3
[SwitchA-Tunnel0] mpls te tunnel-id 10
[SwitchA-Tunnel0] mpls te signal-protocol static
[SwitchA-Tunnel0] mpls te commit
[SwitchA-Tunnel0] quit
Create a static CR-LSP.
5.
# Configure Switch A as the ingress node of the static CR-LSP.
[SwitchA] static-cr-lsp ingress Tunnel0 destination 3.3.3.3 nexthop 2.1.1.2 out-label
20
# Configure Switch B as the transit node of the static CR-LSP.
[SwitchB] static-cr-lsp transit tunnel0 incoming-interface Vlan-interface1 in-label
20 nexthop 3.2.1.2 out-label 30
# Configure Switch C as the egress node of the static CR-LSP.
[SwitchC] static-cr-lsp egress tunnel0 incoming-interface Vlan-interface2 in-label
30
Verify the configuration.
6.
Perform the display interface tunnel command on Switch A. You can find that the tunnel interface
is up.
[SwitchA] display interface tunnel
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 64000
Internet Address is 6.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
84
0/100/0
0/500/0
0/75/0