HP 12500 Series Configuration Manual page 90
Mpls, routing switch series
Hide thumbs
Also See for 12500 Series:
- Configuration manual (338 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
Figure 20 Network diagram
Vlan-int1
2.1.1.2/24
Vlan-int1
2.1.1.1/24
Switch A
Loop0
1.1.1.1/32
Configuration procedure
Assign IP addresses and masks to interfaces (see
1.
Details not shown
Enable IS-IS to advertise host routes with LSR IDs as destinations.
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
[SwitchA-Vlan-interface1] quit
[SwitchA] interface loopback 0
[SwitchA-LoopBack0] isis enable 1
[SwitchA-LoopBack0] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis 1
[SwitchB-isis-1] network-entity 00.0005.0000.0000.0002.00
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] isis enable 1
[SwitchB-Vlan-interface1] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] isis enable 1
[SwitchB-Vlan-interface2] quit
[SwitchB] interface loopback 0
[SwitchB-LoopBack0] isis enable 1
[SwitchB-LoopBack0] quit
# Configure Switch C.
<SwitchC> system-view
Loop0
2.2.2.2/32
Vlan-int2
3.2.1.1/24
Switch B
Vlan-int2
3.2.1.2/24
Switch C
Loop0
3.3.3.3/32
Figure
20).
82
Advertisement
Table of Contents
Troubleshooting
