Establishing Dynamic Lsps Through Ldp; Configuring Mpls Ldp Capability - HP 12500 Series Configuration Manual

To do...
Configure a static LSP taking the
current LSR as a transit LSR
Configure a static LSP taking the
current LSR as the egress
NOTE:
When you configure a static LSP on the ingress LSR, the next hop or outgoing interface specified must be
•
consistent with the next hop or outgoing interface of the optimal route in the routing table. If you
configure a static IP route for the LSP, be sure to specify the same next hop or outgoing interface for the
static route and the static LSP.
• For an ingress or transit LSR, do not specify the public address of an interface on the LSR as the next hop
address.
For information about configuring a static IP route, see
•

Establishing dynamic LSPs through LDP

Configuring MPLS LDP capability

To configure MPLS LDP capability:
To do...
Enter system view
Enable LDP capability globally and
enter MPLS LDP view
Configure the LDP LSR ID
Return to system view
Enter interface view
Enable LDP capability for the
interface
Use the command...
static-lsp transit lsp-name
incoming-interface interface-type
interface-number in-label in-label
{ nexthop next-hop-addr |
outgoing-interface interface-type
interface-number } out-label
out-label
static-lsp egress lsp-name
incoming-interface interface-type
interface-number in-label in-label
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
mpls ldp
lsr-id lsr-id
quit
interface interface-type
interface-number
mpls ldp
12
Remarks
Required
Required
Remarks
—
Required
Not enabled by default
Optional
MPLS LSR ID of the LSR by default
—
—
Required
Not enabled by default
.