Honda CB125 Shine SP Owner's Manual page 64

Installation Notes:
• Position the wheel between the fork
legs and insert the front axle from the
right side, through the right fork leg
and wheel hub.
• Make sure that the tang (8) on the left
front fork leg is located in the slot (9) in
the brake panel.
(9)
(8) Tang ¼VS a x ½
(9) Slot
¼Lyks V ½
• Tighten the front axle nut to the
specified torque.
Front axle nut torque:
54 N·m (5.5 kgf·m , 40 lbf·ft)
60
CB125 Shine SP
• Adjust the brake (page 14-15).
• After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
(8)
Improper assembly may lead to loss of
braking capacity.
Rear Wheel Removal
1. Place the vehicle on its center stand.
2. Remove the drive chain cases (page 53).
3. Remove the rear brake adjusting nut (1).
Disconnect the brake rod (2) from the
brake arm (3).
4. Disconnect the brake stopper arm (4)
from the brake panel by removing
the cotter pin (5) stopper arm nut (6)
washer and rubber grommet.
Honda Motorcycle & Scooter India Pvt. Ltd.