Honda CB125 Shine SP Owner's Manual page 58

3. Inspect the sprocket teeth for possible
wear or damage. Replace if necessary.
Damaged sprocket Teeth
¼{kfrxz L r Liz k W d s V VhFk½
Replace
¼cnys a ½
Normal sprocket Teeth
¼lkekU; Liz k W d s V VhFk½
If the drive chain
excessively worn or damaged, they should
be replaced. Never use a new chain with
worn sprockets; rapid chain wear will result.
4. Install the chain cases and inspection
cap in the reverse order of removal.
54
CB125 Shine SP
Worn sprocket Teeth
¼f?klk gq v k Liz k W d s V VhFk½
Replace
Good
¼lgh½
or sprockets
Adjustment:
Drive chain slack should be checked and
adjusted, if necessary, every 1,000 km
(600 miles). When operated at sustained
high speeds or under conditions of frequent
rapid acceleration, the chain may require
more frequent adjustment.
¼cnys a ½
If the drive chain requires adjustment, the
procedure is as follows:
1. Place the vehicle on its center stand
with the transmission in neutral and the
ignition switch off.
2. Loosen the rear axle nut (1)
3. Loosen the drive chain lock nuts (2).
4. Turn both adjusting nuts (3) an equal
number of turns until the correct
drive chain slack is obtained. Turn the
adjusting nuts clockwise to tighten the
are
chain, or counterclockwise to provide
more slack.
Align the chain adjuster index marks (4)
with the rear edge (5) of the adjusting
slots on both sides of the swingarm.
Honda Motorcycle & Scooter India Pvt. Ltd.