Hardware Switch Settings; Rotary Switches - Omron NX-EIC202 User Manual

4 Part Names and Functions
4-3

Hardware Switch Settings

This section describes the functions of the hardware switches (i.e., the rotary switches and the DIP
switch) on the front panel of the EtherNet/IP Coupler Unit.
4-3-1

Rotary Switches

The two rotary switches show a two-digit hexadecimal number. The setting range is 0x00 to 0xFF with
the default setting 0x00.
x16
x16
Use the rotary switches to specify how to set the IP address of the EtherNet/IP Coupler Unit. The
meanings of the set values are as follows:
Set value (hex)
00
01 to FE
FF
*1. This function is supported for NX-EIC202 version 1.2 or later. An error will occur for earlier versions.
Refer to 9-4 Setting IP Address on page 9-31 for the IP address setting procedure.
4 - 8
1
0
Set the IP address with the Network Configurator.
Set the IP address with the DIP switch (pin 4) and rotary switches.
Get the IP address from the BOOTP server.
IP address setting method
*1
NX-series EtherNet/IP Coupler Unit User's Manual (W536)