Installing The Battery; Replacement Battery; Charging The Battery - Garmin GLO Instruction Manual

Installing the Battery

WarnIng

This product contains a lithium-ion battery.
See page 5 for important battery safety
information.
1
With your thumbnail, slide the battery
cover release tab
the sensor.
➋
2
Remove the battery cover
3
Locate the metal contacts on the end
of the lithium-ion battery.
4
Insert the battery
contacts on the battery align with
the metal contacts inside the battery
compartment.
5
Press the battery down into place.
2
toward the end of
➊
➊
➌
.
➋
so the metal
➌
6
Replace the battery cover by inserting
the tabs into the notches and pressing
the battery cover closed.
The release tab locks the cover in
place.

replacement Battery

You can purchase a replacement battery
(010-10840-00) at http://buy.garmin.com.

Charging the Battery

You can use the sensor while you are
charging it.
1
Plug the small end of the power cable
into the mini-USB connector on the
end of the sensor.
2
Plug the other end of the power cable
into an appropriate source of power for
the cable type.
It takes about three hours to charge the
battery. A fully charged battery lasts about
12 hours.