Genie ZX-135/70 with Jib-Extend Operator's Manual page 53

Third Edition • First Printing
Drive Enable
Light on indicates that the primary
boom has moved past either
circle-end wheel and the drive
function is turned off.
To drive, move the drive enable switch and slowly
move the drive/steer control handle off center.
If the drive/steer control handle is not moved within
two seconds of moving the drive enable switch, the
drive function will not operate. Release and move
the drive enable switch again.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
When the drive enable light is on, the axles cannot
retract.
Engine Idle Select (rpm)
Select the engine idle (rpm) by
pressing the engine idle select
switch. The indicator light next to
the current setting will be on.

Turtle symbol: low idle

Rabbit symbol: high idle
Part No. 1272823GT
Operating Instructions
Check Engine Light
Light on and engine stopped: Tag the
machine and remove from service.
Light on and engine still running:
Contact service personnel within
24 hours.
Operating Envelope Indicator
Lights
The operating envelope indicator lights will come
on to notify the operator that a function has been
interrupted and/or an action is required by the
operator.
Lower/Retract Secondary
Boom indicator light flashing:
Lower/retract the secondary
boom until the indicator light is
off.
Lower Primary Boom indicator
light flashing: Lower the
primary boom until the indicator
light is off.
Machine Not Level indicator
light flashing: The tilt alarm will
be sounding when this light is
flashing.
ZX-135/70
Operator's Manual
51