How To Start The Engine; Before Cranking - Lexus RX300 2003 Owner's Manual

HOW TO START THE ENGINE

Before cranking

1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in "P". If you need to restart the engine
while the vehicle is moving, put the selector lever in "N". A
starter safety device will prevent the starter from operating if
the selector lever is in any drive position.
4. Depress the brake pedal and hold it to the floor until driving
off.
Starting the engine
Before starting the engine, be sure to follow the instructions in
"Before cranking".
Normal starting procedure
The multiport fuel injection system/sequential multiport fuel
injection system in your engine automatically controls the
proper air–fuel mixture for starting. You can start a cold or hot
engine as follows:
1. With your foot off the accelerator pedal, crank the engine by
turning the key to "START". Release it when the engine starts.
2. After the engine runs for about 10 seconds, you are ready
to drive.
If the weather is below freezing, let the engine warm up for a
few minutes before driving. Do not leave the vehicle while the
engine is warming up.
If the engine stalls ...
Simply restart it, using the correct procedure given in normal
starting.
If the engine will not start ...
See "If your vehicle will not start" on page 238.
NOTICE
D Do not crank for more than 30 seconds at a time. This
may overheat the starter and wiring systems.
D Do not race a cold engine.
D If the engine becomes difficult to start or stalls
frequently, have the engine checked immediately.
2003 RX300 from Aug. 02' Prod. (OM48442U)