Configuring Ipv6 Is-Is Mtr - HP MSR Series Configuration Manual

%Aug
DOWN
%Aug
Ethernet0/1 is DOWN
%Aug
0000.0000.0002 (Eth1/1) DOWN, Level-2 Circuit Down.
%Aug
0000.0000.0002 (Eth1/1) DOWN, Level-2 Adjacency clear.
%Aug
0000.0000.0002 (Eth1/1) DOWN, Level-1 Circuit Down.
%Aug
0000.0000.0002 (Eth1/1) DOWN, Level-1 Adjacency clear.
*Aug 8 14:54:05:369 2009 RouterA ISIS/6/ISIS: ISIS-1-BFD: Receive BFD session down .
Type 0. DstIPAddr: FE80::20F:FF:FE00:1200 , SrcIPAddr: FE80::20F:FF:FE00:1202
*Aug 8 14:54:05:370 2009 RouterA ISIS/6/ISIS: ISIS-1-BFD: Success to send msg. Msg
type 1 delete session. IfPhyIndex: 5 ,DstIPAddr: FE80::20F:FF:FE00:1200 , SrcIPAddr:
FE80::20F:FF:FE00:1202 . NeighborType: Level-1.
# Display the BFD information of Router A. You can see that Router A has removed its neighbor
relationship with Router B and therefore no information is output.
<RouterA> display bfd session
# Display route 2001:4::0/64 on Router A, and you can see that Router A and Router B
communicate through Router C.
<RouterA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 1
Destination
NextHop
IpPrecedence :
RelayNextHop : ::
Neighbor
Interface
State
Tunnel ID
Age

Configuring IPv6 IS-IS MTR

Network requirements
As shown in
IPv4 and IPv6 topologies.
8 14:54:05:365 2009 RouterA IFNET/4/LINK UPDOWN: Ethernet1/1: link status is
8 14:54:05:366 2008 RouterA IFNET/4/UPDOWN: Line protocol on the interface
8 14:54:05:367 2009 RouterA ISIS/4/ADJLOG:ISIS-1-ADJCHANGE: Adjacency To
8 14:54:05:367 2009 RouterA ISIS/4/ADJLOG:ISIS-1-ADJCHANGE: Adjacency To
8 14:54:05:368 2009 RouterA ISIS/4/ADJLOG:ISIS-1-ADJCHANGE: Adjacency To
8 14:54:05:369 2009 RouterA ISIS/4/ADJLOG:ISIS-1-ADJCHANGE: Adjacency To
: 2001:4::0
: 2001:2::2
: ::
: Ethernet1/2
: Active Adv
: 0x0
: 4610sec
Figure 96, enable IPv6 IS-IS MTR to make the routers perform route calculation separately in
340
PrefixLength : 64
Preference : 15
QosLcId :
Tag : 0H
ProcessID : 0
Protocol : ISISv6
Cost : 30
Label : NULL